Help Support

Getrag 260/6 selector rod Length ??

Post here for mechanical and engine topics such as fuel issues, transmission problems, rough idle, exhaust, electrical issues, etc

Moderators: bfons, GRNSHRK, ron

Post Reply
User avatar
Rick Eickhoff
Posts: 22
Joined: Wed Nov 07, 2018 4:48 pm
Location: Philadelphia

Getrag 260/6 selector rod Length ??

Post by Rick Eickhoff » Mon Jul 27, 2020 11:16 am

Need to lengthen my UUC - Dual Shear Selector Rod.

Need to get a confirmation of length (pin center to pin center). Have not pulled the actual one out of the car yet. But I attempted to measure it with a pair of large dividers. Looks to be 197mm from pin center to pin center. UUC sent me a 147mm.

Getrag 260/6 from 1986 635csi

My plan is to cut the UUC - DSSR in half then tig weld a 5/8” ID - tube shaft to lengthen to correct size.

If someone in the group knows the selector rod length or has one laying around the shop that could make a quick center to center measurement, I would greatly appreciate it.


Rick Eickhoff
SE Pennsylvania
1988 635csi

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests