I'm about to stick this back on. I've read the posts suggesting silicone sealant, but would be grateful for your thoughts on using a pu product like Sikaflex.
Is there a downside to this? I've used it as a seam sealer lots of times to good effect, and it sure is sticky!
Any thoughts welcome.
Thanks,
Rob
"Most of it necessary; all of it enjoyable." LJKS
'84 635CSi, dogleg...itbs and supercharger????? Eaton Mess
I think if you want to stick it on so that it will come off again you could use something like a contact adhesive (assemble wet) or even.. blu-tack perhaps?
Thanks Ron. Mine spent a considerable amount of time not sitting in the channel at all and has a bit of a fold which prevents it from sitting where it should.
"Most of it necessary; all of it enjoyable." LJKS
'84 635CSi, dogleg...itbs and supercharger????? Eaton Mess