Has anyone repaired the seal channel on the doors? Is there a pre made section available on the web that can be easily adapted?
I'm surprised no one makes these as so many are rusty - also rear outer sills.
Door bottom seal channel repair
Moderators: GRNSHRK, ron, bfons
- randall977
- Posts: 264
- Joined: Sun Jan 21, 2018 9:52 am
- Location: Oxford, UK
- Contact:
Re: Door bottom seal channel repair
What you need are my new doors!
They are ALWAYS rustier than you thought!!!!!!
'85 M #228
'87 M #367
'88 High line.
'10 X5
‘84 Alfasud 1.5 ti
'85 M #228
'87 M #367
'88 High line.
'10 X5
‘84 Alfasud 1.5 ti
-
- Platinum Member
- Posts: 3320
- Joined: Thu Sep 28, 2006 9:28 pm
- Location: scottsdale, arizona
- Contact:
Re: Door bottom seal channel repair
+1 What you need is a replacement door. Repair cost on your door is expensive versus repainting or fitting a door in good condition to begin with. I have been there and done the repair. If I had known what I was getting my self in for, I would have replaced the door. I did go to a sheet metal shop and have new channels made, but none the less I should have gone replacement. I repaired the rust in my front fenders as well and again learned the hard way it would have been better to just have replaced them
81 Euro 635 M90 with motronic. Currently under a complete nut and bolt restoration. Pictures at
flickr.com/photos/bertsphotos.
flickr.com/photos/bertsphotos.