Page 1 of 1
Door bottom seal channel repair
Posted: Fri Mar 30, 2018 3:58 pm
by randall977
Has anyone repaired the seal channel on the doors? Is there a pre made section available on the web that can be easily adapted?
I'm surprised no one makes these as so many are rusty - also rear outer sills.
- Door-Channel.jpg (59.25 KiB) Viewed 2953 times
Re: Door bottom seal channel repair
Posted: Fri Mar 30, 2018 9:08 pm
by ron
What you need are my new doors!
Re: Door bottom seal channel repair
Posted: Sat Mar 31, 2018 12:21 am
by bpoliakoff
ron wrote: ↑Fri Mar 30, 2018 9:08 pm What you need are my new doors!
+1 What you need is a replacement door. Repair cost on your door is expensive versus repainting or fitting a door in good condition to begin with. I have been there and done the repair. If I had known what I was getting my self in for, I would have replaced the door. I did go to a sheet metal shop and have new channels made, but none the less I should have gone replacement. I repaired the rust in my front fenders as well and again learned the hard way it would have been better to just have replaced them