I will slowly hunt you guys down one by one until I find what I am looking for but I feel like compiling a list here first might make life easier.
I acquired a '84 633CSI 9 months ago and have been slowly bringing it back from the dead. It now runs and is once again road worthy. As I get further along, I am starting to replace some items that would be near impossible to find if it wasn't for you folks. Anyways, here is my list, and I am sure to add to it, as well as cross things off as they are gathered.
UPDATED 9/5/2017
-Exterior-
-US Front bumper side covers (both sides) 51111869769 51111869770
X-Tail lights
-Tail light surrounds
X-Head lights
X-Front grilles and kidneys
-Front valance
-Interior-
X-Sun visor clips 51161927473
X-Radio cut out 51161883811
X-heater control knob
X-Rear deck lid covers in Cherry
-Mechanical-
-Muffler (if you are local)
-Front springs
X-Driver side front caliper
Save a Zender Alpine with various parts you dont need (mostly trim)
Moderators: GRNSHRK, ron, bfons
Save a Zender Alpine with various parts you dont need (mostly trim)
Last edited by Jdesign on Tue Sep 05, 2017 7:58 pm, edited 3 times in total.
BMW E24 633CSI - BMW M30B32
BMW E30 325IC - Toyota 1JZ-GTE
BMW E36 318i - Ford 5.0 FE302
https://www.instagram.com/_jdesigner_/
Re: Save a Zender Alpine with various parts you dont need (mostly trim)
What do you need exactly when you say "headlights"? I ask because I have a set of Euro H4/H1 lights I just took out of my 635, and they're priced at less than 1/2 the cost of new. What I mean by lights is just the lights themselves, not the buckets, trim rings, etc. These:
The high beams are very near like new, but one of the low beams has a bit of corrosion on the bottom part of its reflector - the PO was driving the car without the rubber dust boot on that light. Since the low beam light actually is projected off the top half of the reflector, it has little effect on performance. $235 + shipping from rallylights.com, and I'm asking $125 shipped, with brand new bulbs, too. Before I pulled them from the car:
The high beams are very near like new, but one of the low beams has a bit of corrosion on the bottom part of its reflector - the PO was driving the car without the rubber dust boot on that light. Since the low beam light actually is projected off the top half of the reflector, it has little effect on performance. $235 + shipping from rallylights.com, and I'm asking $125 shipped, with brand new bulbs, too. Before I pulled them from the car:
Dean
Lutz, FL
'85 635 CSi Euro #9402254
'87 Spider Veloce
'92 Spider Veloce
'08 350Z
Lutz, FL
'85 635 CSi Euro #9402254
'87 Spider Veloce
'92 Spider Veloce
'08 350Z
Re: Save a Zender Alpine with various parts you dont need (mostly trim)
Sorry, yes just the lights and not the buckets or trim. Those are really nice but I think they might be nicer and more expensive than what I am looking for at the moment.dwcains wrote:What do you need exactly when you say "headlights"? I ask because I have a set of Euro H4/H1 lights I just took out of my 635, and they're priced at less than 1/2 the cost of new. What I mean by lights is just the lights themselves, not the buckets, trim rings, etc. These:
The high beams are very near like new, but one of the low beams has a bit of corrosion on the bottom part of its reflector - the PO was driving the car without the rubber dust boot on that light. Since the low beam light actually is projected off the top half of the reflector, it has little effect on performance. $235 + shipping from rallylights.com, and I'm asking $125 shipped, with brand new bulbs, too. Before I pulled them from the car:
BMW E24 633CSI - BMW M30B32
BMW E30 325IC - Toyota 1JZ-GTE
BMW E36 318i - Ford 5.0 FE302
https://www.instagram.com/_jdesigner_/
Re: Save a Zender Alpine with various parts you dont need (mostly trim)
Bumpity
BMW E24 633CSI - BMW M30B32
BMW E30 325IC - Toyota 1JZ-GTE
BMW E36 318i - Ford 5.0 FE302
https://www.instagram.com/_jdesigner_/
Re: Save a Zender Alpine with various parts you dont need (mostly trim)
tschultz- PM'd me. Waiting for pictures of what he might have.
Im still looking for usable parts, nothing in perfect or rare condition. Anyone?
Im still looking for usable parts, nothing in perfect or rare condition. Anyone?
BMW E24 633CSI - BMW M30B32
BMW E30 325IC - Toyota 1JZ-GTE
BMW E36 318i - Ford 5.0 FE302
https://www.instagram.com/_jdesigner_/
Re: Save a Zender Alpine with various parts you dont need (mostly trim)
Sent pictures to you for a few items, let me know what you think.
http://www.Drive4Corners.com
'79 635CSi Revival
'80 635CSi
'83 633CSi Callaway Turbo continued as 1988 535is Turbo
SOLD: '81 635CSi/A
'79 635CSi Revival
'80 635CSi
'83 633CSi Callaway Turbo continued as 1988 535is Turbo
SOLD: '81 635CSi/A
Re: Save a Zender Alpine with various parts you dont need (mostly trim)
Replied, Thanks!
BMW E24 633CSI - BMW M30B32
BMW E30 325IC - Toyota 1JZ-GTE
BMW E36 318i - Ford 5.0 FE302
https://www.instagram.com/_jdesigner_/
Re: Save a Zender Alpine with various parts you dont need (mostly trim)
BUMP for updated content
I only need the following now:
-Exterior-
-US Front bumper side covers (both sides) 51111869769 51111869770
-Tail light surrounds
-Front valance
-Mechanical-
-Muffler (if you are local)
-Front springs
I only need the following now:
-Exterior-
-US Front bumper side covers (both sides) 51111869769 51111869770
-Tail light surrounds
-Front valance
-Mechanical-
-Muffler (if you are local)
-Front springs
BMW E24 633CSI - BMW M30B32
BMW E30 325IC - Toyota 1JZ-GTE
BMW E36 318i - Ford 5.0 FE302
https://www.instagram.com/_jdesigner_/