Help Support Bigcoupe.com

Blower Control Repair w/ pics!

This forum is dedicated to technical write-ups contributed by Bigcoupe.com members. Please submit an article you have written to [email protected] in order to have your article posted.

Moderators: ron, bfons, GRNSHRK

JoelR
Posts: 47
Joined: Sun Mar 09, 2014 4:19 am
Location: DFW (Plano) Texas

Re: Blower Control Repair w/ pics!

Post by JoelR » Sat Jan 18, 2020 8:53 pm

So my heater fan stopped blowing at any setting, but the A/C fan worked fine for all settings. I replaced the transistor by the heater fan with the 2N3771, and the fan started working, but only on high. It did this a few times, then it quit working altogether. The A/C fan is still working fine.

The heater fan was not making any bearing noises. I could rotate it by hand, and it was a little stiff, but I don't have any reference to compare it to in order to know if this is normal or if it has too much resistance.

I have not torn into the dash controls yet because the A/C fan is operating normally, so I tend to think the potentiometer and the transistor in there are OK.

Is there any reason to suspect the dash controls, or should I suspect the fan motor?
1983 633 5-speed Black & Tan
DFW Texas

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest