Picture of solenoid wiring for a 1988 bmw 635csi

Post here for mechanical and engine topics such as fuel issues, transmission problems, rough idle, exhaust, electrical issues, etc

Moderators: GRNSHRK, ron, bfons

Post Reply
Scott635csi
Posts: 6
Joined: Sat Oct 20, 2018 1:19 pm
Location: St Louis, MO

Picture of solenoid wiring for a 1988 bmw 635csi

Post by Scott635csi »

picture of solenoid
picture of solenoid
WP_20210516_011.jpg (1.71 MiB) Viewed 1908 times
picture of solenoid
picture of solenoid
WP_20210516_009.jpg (1.86 MiB) Viewed 1908 times
I have had this issue for a while and need to get this car started up. It will not crank, I found a loose black wire on a bayonet female hanging, I have pictures of the wire in question, any assist would be greatly appreciated. The battery is fully charged and I must of broken or pulled out something when I was changing the radiator hose. I would like to start driving the vehicle now that I'm retired and have time. I any body has a picture of the wire config, so I can reattach the lose wire to the proper terminal.

Thanks guys,

Scott
User avatar
86_6series
Platinum Member
Platinum Member
Posts: 1069
Joined: Mon Apr 02, 2007 10:08 pm
Location: West Nyack, NY

Re: Picture of solenoid wiring for a 1988 bmw 635csi

Post by 86_6series »

First I would make certain that the wire is in fact to
trigger the solenoid. Multi meter or circuit tester will confirm.

This is the terminal tab where the wire slides onto.
OP.jpg
OP.jpg (19.99 KiB) Viewed 1888 times
86-635CSi
96-MB C220 SOLD
98-740i
71-Continental MK3
Post Reply